Serial Port not Working

Please provide the following information:

[  ]x FlightBox Kit
[  ] FlightBox Assembled (FB1X)
[  ] Generic Stratux

FlightBox / Stratux version: (e.g. "v0.8r2" or "v1.0r1")

FlightBox / Stratux build: (e.g. "db130aab76")

Radio Configuration:
[  ]x Dual Band
[  ] Single Band - US / CA - 978 MHz UAT
[  ] Single Band - International - 1090-ES

GPS Configuration:
[  ] None - Using mobile device's GPS
[  x] Open Flight Solutions Remote GPS
[  ] Internal GPS Module (VK-172)
[  ] Other:

USB Power Source:
[  ] USB Battery: (Make / Model Here)
[  ] Cigarette Lighter Adapter: (Make / Model Here)

USB Cable:
[  ] x3' heavy gauge cable included with FlightBox
[  ] Other: (Make / Model / Description Here)

EFB Application name and version:

Please include a detailed description of your issue or question:
I have the serial usb cable connected to my GRT EFISs and it used to work but now the serial input counters are running very slow in both my EFISs even though the data rate is 115.2K .

Since I have some data flowing to the EFISs would the most likely problem be a defective Serial USB cable?

My IPad shows the ADS-B to be working ok and I saw traffic on my IPad.

Any thoughts on this?

Can you please post a pic (or several if you have to scroll to get it all) of the Settings page on your FlightBox’s web interface? That will give me a decent place to start in debugging the issue.



Thanks Steven,
I finally had time this morning to use the web interface and discovered I had a baud rate mismatch. I’m not quite sure how I did that but I changed the FlightBox to 115.2K and it seemed to now work.
Thanks for your suggestions,