Please provide the following information:
Hardware:
[ ] FlightBox Kit
[x ] FlightBox Assembled (FB1X)
[ ] Generic Stratux
FlightBox / Stratux version: (e.g. "v0.8r2" or "v1.0r1")
2.0r4
FlightBox / Stratux build: (e.g. “db130aab76”)
Radio Configuration:
[x ] Dual Band
[ ] Single Band - US / CA - 978 MHz UAT
[ ] Single Band - International - 1090-ES
GPS Configuration:
[ ] None - Using mobile device's GPS
[x ] Open Flight Solutions Remote GPS
[ ] Internal GPS Module (VK-172)
[ ] Other:
USB Power Source:
[ ] USB Battery: (Make / Model Here)
[x ] Cigarette Lighter Adapter: (Make / Model Here)
USB Cable:
[ x ] 3' heavy gauge cable included with FlightBox
[ ] Other: (Make / Model / Description Here)
EFB Application name and version:
Please include a detailed description of your issue or question:
My 1090ES radio died in my Flightbox Pro. I wasn’t getting data on 1090ES, only UAT, and there was only 1 SDR recognized on the status page. Ordered and installed a new 1090ES SDR and now status shows 2 SDRs so that problem is fixed.
My current issue is no data would show up on the 1090es which I thought was odd as I always used to get 1090es signals in the hangar. Thought I might have a second bad SDR until I went to settings and disabled UAT radio. When I did that and went back to status page, packets started pouring in on the 1090ES.
I don’t believe I have ever had to do this previously and can’t imagine having to go in each time I fly and disable one radio and then re-enable it to get 1090 ES to start working.
Anyone else have this issue and if so why it would happen and what can be done about it? I did put the newest firmware on the Flightbox which is 2.0r4.
Thanks!